OM 606 head porting

STD Tuning Engine OM 606 head porting

OM 606 head porting

View a Printable Version

0 Vote(s) - 0 Average

firen456

TA 0301

73

01-14-2019, 01:21 PM #9

Yes, had to mill the gaps in the pistons. But not that much. Only like 0.5-1mm. I did that free hand with a real mans dremel. You have to work very carefully. But it would be better to get the pistons out the engine and do the job on a mill.

firen456

01-14-2019, 01:21 PM #9

View a Printable Version

0 Vote(s) - 0 Average

Messages In This Thread

OM 606 head porting - by zeeman - 01-13-2019, 12:03 PM

RE: OM 606 head porting - by firen456 - 01-13-2019, 12:38 PM

RE: OM 606 head porting - by zeeman - 01-13-2019, 09:00 PM

RE: OM 606 head porting - by zeeman - 01-14-2019, 10:36 PM

RE: OM 606 head porting - by firen456 - 01-14-2019, 01:40 AM

RE: OM 606 head porting - by zeeman - 01-14-2019, 02:14 AM

RE: OM 606 head porting - by firen456 - 01-14-2019, 07:41 AM

RE: OM 606 head porting - by zeeman - 01-14-2019, 12:03 PM

RE: OM 606 head porting - by zeeman - 01-14-2019, 10:33 PM

RE: OM 606 head porting - by JoeB - 01-14-2019, 11:09 AM

RE: OM 606 head porting - by firen456 - 01-14-2019, 01:21 PM

RE: OM 606 head porting - by firen456 - 01-15-2019, 06:44 AM

Users browsing this thread:
1 Guest(s)