Rev counters... talk to me
Rev counters... talk to me
09-29-2013, 05:17 PM
#1
The rev counter uses pulses taken from the starter ring on the flywheel. Now I have 2 problems; I need to move the sensor because the starter ring on the 611 single mass flywheel isnt in the right place, and the flywheel has a different amount of teeth. The first one isn't a massive issue but the second problem is.
My old flywheel from my 602 has 164 teeth, whereas my new flywheel has 144 teeth. Due to this my rev counter will be wrong. Is there ssme way of correcting this?
Im about to put my 606 into my 190 but ive hit a problem and I dont know how to get round it.
The rev counter uses pulses taken from the starter ring on the flywheel. Now I have 2 problems; I need to move the sensor because the starter ring on the 611 single mass flywheel isnt in the right place, and the flywheel has a different amount of teeth. The first one isn't a massive issue but the second problem is.
My old flywheel from my 602 has 164 teeth, whereas my new flywheel has 144 teeth. Due to this my rev counter will be wrong. Is there ssme way of correcting this?
09-30-2013, 04:14 AM
#2
W124 om606 HX40 finished and it's a beauty 450bhp/456ft-lbs
maxypriest
09-30-2013, 04:14 AM #2Just an idea - you could use a rev counter from a w124 diesel and bodge it into the 201 cluster?
W124 om606 HX40 finished and it's a beauty 450bhp/456ft-lbs
10-06-2013, 07:01 PM
#4
'82 300D -3" straight pipe, ALDA deleted, 3in1 glowshift gauge, HX30, egr-less manifold, A/W intercooler
'14 Ram 6.7l cummins -G56 handshaker, wishing it was deleted
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Users browsing this thread:
1 Guest(s)
1 Guest(s)