300D build thread (finally)
300D build thread (finally)
(06-05-2013, 09:09 PM)MFSuper90 I just made sure the ID of the pipe was the same as the comp housing. The way I made it it sat right inside a ledge so it was centered perfectly.
The lathe might have been a little overkill, but it's our only lathe.
Old hendley, they used it to make gun barrels in WWII.
That's our Bridgeport to the left, not very good with it yet.
(06-05-2013, 09:09 PM)MFSuper90 I just made sure the ID of the pipe was the same as the comp housing. The way I made it it sat right inside a ledge so it was centered perfectly.
The lathe might have been a little overkill, but it's our only lathe.
Old hendley, they used it to make gun barrels in WWII.
That's our Bridgeport to the left, not very good with it yet.