injection noise/nailing

STD Tuning Engine injection noise/nailing

View a Printable Version

0 Vote(s) - 0 Average

tomnik

Holset

587

05-05-2010, 02:57 PM #8

look into the pre chamber with a torch and check if the ball inside is still there. Sometimes it happened that the ball is blown/melted/broken away and this will cause also nailing on one single cylinder.

Tom

(05-05-2010, 11:48 AM)willbhere4u What should I look for? Dose it come out?

tomnik

05-05-2010, 02:57 PM #8

(05-05-2010, 11:48 AM)willbhere4u What should I look for? Dose it come out?

View a Printable Version

0 Vote(s) - 0 Average

Messages In This Thread

injection noise/nailing - by willbhere4u - 05-03-2010, 09:27 PM

RE: injection noise/nailing - by dude99 - 05-03-2010, 09:54 PM

RE: injection noise/nailing - by willbhere4u - 05-03-2010, 10:02 PM

RE: injection noise/nailing - by Alastair E - 05-04-2010, 01:39 PM

RE: injection noise/nailing - by willbhere4u - 05-04-2010, 08:42 PM

RE: injection noise/nailing - by tomnik - 05-05-2010, 06:37 AM

RE: injection noise/nailing - by willbhere4u - 05-05-2010, 11:48 AM

RE: injection noise/nailing - by tomnik - 05-05-2010, 02:57 PM

RE: injection noise/nailing - by willbhere4u - 05-05-2010, 05:28 PM

RE: injection noise/nailing - by Einar - 05-07-2010, 01:37 AM

RE: injection noise/nailing - by willbhere4u - 05-07-2010, 09:14 AM

Users browsing this thread:
1 Guest(s)