Pre Chamber Special Tool
Pre Chamber Special Tool
01-22-2019, 12:53 AM
#1
a few weeks ago, i have a damage on the cylinder head gaskit, the water goes to the outside... (OM602.939)
so, to make it rigth, i want to put the Prechambers out, but the ring was thigt, very thigt.
![[Image: 34894592on.jpg]](https://up.picr.de/34894592on.jpg)
![[Image: 34894593qb.jpg]](https://up.picr.de/34894593qb.jpg)
![[Image: 34894594or.jpg]](https://up.picr.de/34894594or.jpg)
![[Image: 34894595xo.jpg]](https://up.picr.de/34894595xo.jpg)
two Adapters from 1/2" to 3/4" crack.
the thrid one hold.
To never get this Problem, i build this tool:
the Material is a 32mm Allen key and i have tournd and mill it.
it fit great, like the original from Stahlwille.
![[Image: 34894606ig.jpg]](https://up.picr.de/34894606ig.jpg)
![[Image: 34894609yf.jpg]](https://up.picr.de/34894609yf.jpg)
Steffen
German Diesel
01-22-2019, 12:53 AM #1Hi Guys,
a few weeks ago, i have a damage on the cylinder head gaskit, the water goes to the outside... (OM602.939)
so, to make it rigth, i want to put the Prechambers out, but the ring was thigt, very thigt.
two Adapters from 1/2" to 3/4" crack.
the thrid one hold.
To never get this Problem, i build this tool:
the Material is a 32mm Allen key and i have tournd and mill it.
it fit great, like the original from Stahlwille.
Steffen
Messages In This Thread
Pre Chamber Special Tool - by German Diesel - 01-22-2019, 12:53 AM
RE: Pre Chamber Special Tool - by AlanMcR - 01-22-2019, 09:42 PM
RE: Pre Chamber Special Tool - by zeeman - 01-23-2019, 02:14 AM
RE: Pre Chamber Special Tool - by German Diesel - 01-25-2019, 11:26 AM
RE: Pre Chamber Special Tool - by Mallinman - 01-26-2019, 02:08 PM
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Users browsing this thread:
1 Guest(s)
1 Guest(s)