New Project - Skunkwerks EM9D
New Project - Skunkwerks EM9D
I am working on my Water Injection system and should have it installed this weekend. I originally had it installed on my truck, but I don't really use it so I figured I would swap it over to the Benz.
I have a Flojet pump that needed a new check valve assembly - $25.00 from a local distributor. The valves were warped and it didn't pump a squirt. It works fine now and puts out 140 psi.
I am going to install one nozzle in the intake, after the IC and facing toward the rear of the engine. This should distribute the atomized mix very well.
I am going to use a M14 thead instead if the M16 in the sketch, this will allow me to easily change the nozzle size if I need to.
A few pics of the players and more to follow after installation.
Quick sketch of nozzle assembly
Finished assembly
20 psi fixed pressure switch
12VDC solenoid valve