New Project - Skunkwerks EM9D
New Project - Skunkwerks EM9D
Oh yeah that 396 place has it! to bad their dollar sign is all weird and screwy...
Ok, so I didn't pay attention to what the cooler tanks are made from.. Aluminum? I would weld in a aluminum bung then tape it to accept a -8 (3/4-16) or -10 thread (7/8-14) so you could use one of my fittings above with an o-ring seal. that would make the fitting as close to the cooler as possible. You could do it with NPT, but there's always a small chance of galling, plus they are more permanent... but you know that!