New Project - Skunkwerks EM9D
New Project - Skunkwerks EM9D
I started to disassemble my current setup and have embarked on the installation of project Skunkwerks-EM9D. Albiet it is not much now, I was able to remove the OEM exhaust so I can build a jig to maintain the path, angles and planes.
The plan:
1. Clean remaining crud from block
2. Change motor mounts while I have easy access
3. Change motor shocks for reasons in number 2
4. Change timing chain and tensioner
5. Change flex discs
Once the above items are completed I will install the S/C so I can finish the intake portion of that sub project.
After completion of the above, I should have my pump...it is almost done, then the fun will begin.