Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
OM 606 Deck Height
zeeman Online
Holset
****


Posts: 389
Joined: Jan 2012
Location: Idaho
#1
OM 606 Deck Height
I have a 606 block in the machine shop to be bored for new pistons. They just called and suggested that it needs to be surfaced to clean up the head gasket surface.
What is the allowed amount that can be taken off to be safe? If it is an issue we can always resize the rods to make up the difference.
05-05-2020, 11:19 AM
Find Reply
barrote Offline
Superturbo
*****


Posts: 1,564
Joined: Dec 2011
Location: Portugal
#2
RE: OM 606 Deck Height
A lot... if needed. Just to clear a gasket .1mm sufice and u can use a stock gasket. But u should acess CR
FD,
Powered by tractor fuel
05-06-2020, 11:32 AM
Find Reply
zeeman Online
Holset
****


Posts: 389
Joined: Jan 2012
Location: Idaho
#3
RE: OM 606 Deck Height
barrote Wrote:A lot... if needed. Just to clear a gasket .1mm sufice and u can use a stock gasket. But u should acess CR
Are there any thicker head gaskets available?
05-06-2020, 12:11 PM
Find Reply
AlanMcR Offline
mind - blown
****


Posts: 319
Joined: May 2009
Location: USA
#4
RE: OM 606 Deck Height
A6060160520 Cylinder head gasket 1.85mm (vs. 1.65mm)
05-07-2020, 03:41 PM
Find Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)