Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
OM606/648 OIL PAN GASKET
50harleyrider Offline
Holset
****


Posts: 276
Joined: Jun 2015
Location: usa
#1
OM606/648 OIL PAN GASKET
Does anyone have insight into the best way to seal these pans? I have a 648 rear sump pan on my 606 swap and pan is leaking. I haven't had any luck sourcing a pan gasket so I assume there must be a sealing technique i'm not aware of. I have a tube of Elring Dirko Grey which I assume is a high end European RTV but want to apply it correctly and torque the pan bolts correctly.
(This post was last modified: 01-14-2020, 01:35 PM by 50harleyrider.)
01-14-2020, 01:30 PM
Find Reply
frans-c Offline
K26-2
*


Posts: 38
Joined: Aug 2016
Location: South Africa
#2
RE: OM606/648 OIL PAN GASKET
Surely you can get one at a dealership? They're not too expensive. I've tried the RTV route - unless the two mating surfaces are bone-dry (good luck with that - oil keeps draining down the engine block), it's going to leak. Had to re-do it with the proper metal gasket.
01-15-2020, 06:53 AM
Find Reply
50harleyrider Offline
Holset
****


Posts: 276
Joined: Jun 2015
Location: usa
#3
RE: OM606/648 OIL PAN GASKET
Do you have a part number? I am using a 648 pan on a 606
01-15-2020, 11:46 AM
Find Reply
frans-c Offline
K26-2
*


Posts: 38
Joined: Aug 2016
Location: South Africa
#4
RE: OM606/648 OIL PAN GASKET
A6060140022 or A6480140022, but they both look the same to me.
(This post was last modified: 01-16-2020, 06:45 AM by frans-c.)
01-16-2020, 06:43 AM
Find Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)