Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Sprinter SMF Kits
WDiesel Offline
K26-2
*


Posts: 27
Joined: Mar 2013
Location: Kalifas
#1
Sprinter SMF Kits
I've seen varying views on using Sprinter SMF on the OM606. I currently have a sprinter Single mass flywheel and clutch kit on my OM606 and 716.xxx from a C230 kompressor. 

I've been told that the tab on the crank is 11.3mm and the key hole for the tab that's on the flywheel is only 10.3mm deep. Such as this thread here
https://www.mb4x4.co.za/index.php?thread...heel.2791/

I'm confused - i almost want to remove my trans and flywheel to verify everything with a caliper. Whats your experience with this?
Check out my build:
 https://bit.ly/2sisie9
08-12-2019, 03:33 PM
Find Reply
Petar Offline
7.5mm M pump
****


Posts: 437
Joined: Feb 2014
Location: Serbia
#2
RE: Sprinter SMF Kits
My friend had to grind it down on a 605, the tab was 11.8mm but the hole was only 10.8mm so he ground it down to 10.5mm
08-13-2019, 04:58 AM
Find Reply
WDiesel Offline
K26-2
*


Posts: 27
Joined: Mar 2013
Location: Kalifas
#3
RE: Sprinter SMF Kits
Thanks for that. I'm curious to see who has had failures because of this.
Check out my build:
 https://bit.ly/2sisie9
08-15-2019, 01:09 AM
Find Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)