722.6 w210 stall speed
722.6 w210 stall speed
The EZ-TCU does not let you olay with the system pressure. I set the speed and tps at 50mph and 30% respectively. Let me know if in your opinion either is a bit off, they seem/feel resonable to me. One problem I suspect is that, since the 603/6mm pump does not deliver much at low rpm, I have to push the gas pedal to the point that the TCU down-shifts when normally it would not be necessary considering the moderate power/fuel I command. This in turn also increases line pressure, I think, far more than necessary for the torque/HP being generated. So TCU know TPS demand but does jot know fuel/power output. Hope you get what I mean.
I’m currently controlling the GT23V with boost actuator, so not very precise. Just got Baldur’s ECU and I will try to control the GT by vacuum with this ECU.