Fitting an OM606 Turbo into a RHD w114 (steering interference)
Fitting an OM606 Turbo into a RHD w114 (steering interference)
I could really do with some advice here.
I hear there are issues with the Turbo/exhaust interfering with the steering column in a Right Hand Drive W114.
How do I get around this issue? Has the interefering bits been rerouted without losing performance?
Any help appreciated. Also, do I assume that a normally aspirated OM605 or OM606 would fit without issue (apart from the front crossmember chops)
Warmest Regards
Udhi
ChasesDragons
03-23-2018, 05:40 AM #1Hi all,
I could really do with some advice here.
I hear there are issues with the Turbo/exhaust interfering with the steering column in a Right Hand Drive W114.
How do I get around this issue? Has the interefering bits been rerouted without losing performance?
Any help appreciated. Also, do I assume that a normally aspirated OM605 or OM606 would fit without issue (apart from the front crossmember chops)
Warmest Regards
Udhi
I had a 617A in my RHD 123 and the only issue was the air filter housing rubbing on a brake line at the master cylinder
1978 300D, 373,000km... OM617.912 with a Holset HX30W, 7.5mm IP, 711.113 5 speed (project car, 7 years off the road and counting ;/)
1977 250 270,000km (parts car)
1977 300D (ex 280) 500,000km
1981 240D 498,000
1975 HJ45 ???,000
2001 2.8TD Rodeo 4x2 - 456,000 - DD
Can't help with the /8 but other RHD cars like 116 and 123 take 60x just fine. You should get a new exhaust made when doing the swap regardless.
I had a 617A in my RHD 123 and the only issue was the air filter housing rubbing on a brake line at the master cylinder
1978 300D, 373,000km... OM617.912 with a Holset HX30W, 7.5mm IP, 711.113 5 speed (project car, 7 years off the road and counting ;/)
1977 250 270,000km (parts car)
1977 300D (ex 280) 500,000km
1981 240D 498,000
1975 HJ45 ???,000
2001 2.8TD Rodeo 4x2 - 456,000 - DD
Even a talented boy like Monstercrawlers had chosen a lhd to install the om606 in the UK.
ChasesDragons
03-24-2018, 02:22 PM #3Thank You mate. My concern is the wiggle room available to avoid the interference. I am not sure what exactly interferes and if it can br worked around.
Even a talented boy like Monstercrawlers had chosen a lhd to install the om606 in the UK.
ChasesDragons
04-28-2018, 07:12 AM #4Anyone? This is probably too simple and boring question for most of you here, but its seriously hamstringimg my dreams.
I can't help from direct experience but only option seems to be to create a new manifold to move everything out of the way. W114/5 is much narrower than W123, W126. Less room to get everything in. With regard to loss of performance, if manifold well designed, no sharp angles it should be a negligible difference. It's not like a naturally asparated petrol engine where manifold shape makes a bigger difference to fueling, as the fuel is injected and the air is wumped in by the turbo.
1 Guest(s)
1 Guest(s)