722.6 Output flange shims
722.6 Output flange shims
11-28-2016, 02:36 PM
#1
Can some one tell me the part no. or dimensions of the output flange shims on the 722.6?
Also does anyone have and EPC drawing of where they go in relation to the output flange, and the output flange nut; i.e. before the flange, or between the flange and nut?
Thanks
Mat
Hi,
Can some one tell me the part no. or dimensions of the output flange shims on the 722.6?
Also does anyone have and EPC drawing of where they go in relation to the output flange, and the output flange nut; i.e. before the flange, or between the flange and nut?
Thanks
Mat
![[Image: det_expl_920_1.jpg]](http://www.newco-autoline.de/img/temp/det_expl_920_1.jpg)
11-28-2016, 04:03 PM
#3
The reason I'm asking is I have quite a lot of play in the rear output flange and was hoping i'd lost a shim when having it machined.
That looks good... by the looks of things there, the shims I'm after are #270, this seems to be behind the oil seal and a circlip though, is this correct, or can the shims be pulled out when the output flange is removed?
The reason I'm asking is I have quite a lot of play in the rear output flange and was hoping i'd lost a shim when having it machined.
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Users browsing this thread:
1 Guest(s)
1 Guest(s)