STD Other Non MBZ Diesel BMW EVRY Mod

BMW EVRY Mod

BMW EVRY Mod

 View a Printable Version
 
  • 0 Vote(s) - 0 Average
 
whitey1986
Find
GTA2056V

91
03-05-2016, 01:24 PM #2
Reply
Reply
If you remove the injection pump plug the one which comes from the pump and goes to a connector just underneath you will notice under the rubber cover the wires have numbers. If you wire an 800 ohm variable resistor to wires 2 and 3 it will give the desired effect. I recommend you increase the boost with a boost controller however this will cause fuel cut. To prevent this you can unplug the maf and map sensor and then unplug the battery for 10 minutes to allow the ecu to use the precalculated maf and map values rather than the sensor values. This will prevent fuel cut. I also think you should look up endtuning and get his ecu chip installed.
whitey1986
03-05-2016, 01:24 PM #2

If you remove the injection pump plug the one which comes from the pump and goes to a connector just underneath you will notice under the rubber cover the wires have numbers. If you wire an 800 ohm variable resistor to wires 2 and 3 it will give the desired effect. I recommend you increase the boost with a boost controller however this will cause fuel cut. To prevent this you can unplug the maf and map sensor and then unplug the battery for 10 minutes to allow the ecu to use the precalculated maf and map values rather than the sensor values. This will prevent fuel cut. I also think you should look up endtuning and get his ecu chip installed.

Reply
Reply
 View a Printable Version
 
  • 0 Vote(s) - 0 Average

Messages In This Thread
BMW EVRY Mod - by silverzx - 12-01-2015, 09:41 AM
RE: BMW EVRY Mod - by whitey1986 - 03-05-2016, 01:24 PM
Users browsing this thread:
 1 Guest(s)
Users browsing this thread:
 1 Guest(s)