stiff brakes after new master cyl.

STD Tuning Brakes stiff brakes after new master cyl.

View a Printable Version

0 Vote(s) - 0 Average

nevrenufhp

Naturally-aspirated

4

09-15-2012, 06:58 PM #1

I thought for sure I bled them really well. I've done my fair share of mechanicing. I swapped out my old one because it started bleeding down at a stoplight. Put in the new one after the bench bleed, but the pedal is stiff, and it's as hard to push as my 67 F100 with 4 wheel drums. Should I go back to bleeding the whole thing one more time? This is getting tiresome.

82 300SD
67 F100, 300
Low Buck fuel rate how-to site

nevrenufhp

09-15-2012, 06:58 PM #1

82 300SD
67 F100, 300
Low Buck fuel rate how-to site

aaa

GT2256V

913

09-15-2012, 07:22 PM #2

Replace the seal between the master cylinder and brake booster. Or it could be a bad brake booster.

aaa

09-15-2012, 07:22 PM #2

Replace the seal between the master cylinder and brake booster. Or it could be a bad brake booster.

nevrenufhp

Naturally-aspirated

4

09-15-2012, 07:29 PM #3

That was my next avenue. If I push on it slowly, it acts a lot better.
Thanks kind sirrr

82 300SD
67 F100, 300
Low Buck fuel rate how-to site

nevrenufhp

09-15-2012, 07:29 PM #3

That was my next avenue. If I push on it slowly, it acts a lot better.
Thanks kind sirrr

82 300SD
67 F100, 300
Low Buck fuel rate how-to site

View a Printable Version

0 Vote(s) - 0 Average

Users browsing this thread:
1 Guest(s)