STD Tuning Engine Turbo rods on N/A crank?

Turbo rods on N/A crank?

Turbo rods on N/A crank?

 View a Printable Version
 
  • 0 Vote(s) - 0 Average
 
bad3gakk
Website Find
om605 - kkk27 - w124

52
04-02-2012, 11:17 AM #1
Reply
Reply
Would 606 turbodiesel rods fit an 605 N/A crank?
Since the 606 and 605 turbodiesels share pistons and rods, you could interchange there.. but i dont know if the crank bearings are the same size...
bad3gakk
04-02-2012, 11:17 AM #1

Would 606 turbodiesel rods fit an 605 N/A crank?
Since the 606 and 605 turbodiesels share pistons and rods, you could interchange there.. but i dont know if the crank bearings are the same size...

Reply
Reply
hansendk
Unregistered

 
04-02-2012, 11:32 PM #2
Reply
Reply
the crankshaft is the same std. size 47.950-47.965 mm.
but the bearings are not, turbo`s are sputter type

you cant take the conrod from a turbo and use n/a pistons the piston pins are not the same size.
hansendk
04-02-2012, 11:32 PM #2

the crankshaft is the same std. size 47.950-47.965 mm.
but the bearings are not, turbo`s are sputter type

you cant take the conrod from a turbo and use n/a pistons the piston pins are not the same size.

Reply
Reply
 View a Printable Version
 
  • 0 Vote(s) - 0 Average
Users browsing this thread:
 1 Guest(s)
Users browsing this thread:
 1 Guest(s)