DIY: W123 Bumper tuck.
DIY: W123 Bumper tuck.
The mouldings are attached via three bolts, two up high and one down low. For both the front and rear I believe. I know that the bottom one would not be covered up by pulling the bumper forward, but it is possible that one of the other could be.
I don’t know if you can see this, but I went wayyy back in the FB archives to pull up a picture of one of my 300D’s that was painted. We pulled the bumpers, so you may be able to see the holes on the left quarter panel.
Bumper Pic