Turbo Information Thread (Needs your contributions!)
Turbo Information Thread (Needs your contributions!)
(10-29-2013, 07:15 AM)MFSuper90(10-29-2013, 05:01 AM)EDH_Performance Holset HE300WG
Compressor:
58mm Inducer/85mm Exducer
Turbine: 8cm2 housing with special "t4" flange
Inducer 65mm/Exducer 52mm
Can flow 66lbs/min and pr of 5
Is that a t4i flange? It's very close to a t4, but will not bolt up without modding the holes a little
(10-29-2013, 07:15 AM)MFSuper90(10-29-2013, 05:01 AM)EDH_Performance Holset HE300WG
Compressor:
58mm Inducer/85mm Exducer
Turbine: 8cm2 housing with special "t4" flange
Inducer 65mm/Exducer 52mm
Can flow 66lbs/min and pr of 5
Is that a t4i flange? It's very close to a t4, but will not bolt up without modding the holes a little