Prechamber Mod "Flame" Front
Prechamber Mod "Flame" Front
(12-27-2012, 06:12 PM)MFSuper90(12-26-2012, 06:11 PM)OM616(12-24-2012, 05:42 PM)MFSuper90 How did you go about enlarging the injector seat? And what is the purpose of doing this?
I have an extra head laying around so I think I will try out some modded PC's also. Sounds like a cheap and worthwhile mod
I used my lathe and a boring bar. You do not want to use a drill!!! You will hit the ball!!!
I imagine the larger area helps clear out the injector tip with fresh air. MB says to do this to help reduce smoke, and it is standard on 85 models I think.
I don't have a boring bar small enough to do that, so maybe I'll just skip that step.
Our lathe is a hendley that was used in WWII, good lathe but its much too big for something as small as a prechamber
(12-27-2012, 06:12 PM)MFSuper90(12-26-2012, 06:11 PM)OM616(12-24-2012, 05:42 PM)MFSuper90 How did you go about enlarging the injector seat? And what is the purpose of doing this?
I have an extra head laying around so I think I will try out some modded PC's also. Sounds like a cheap and worthwhile mod
I used my lathe and a boring bar. You do not want to use a drill!!! You will hit the ball!!!
I imagine the larger area helps clear out the injector tip with fresh air. MB says to do this to help reduce smoke, and it is standard on 85 models I think.
I don't have a boring bar small enough to do that, so maybe I'll just skip that step.
Our lathe is a hendley that was used in WWII, good lathe but its much too big for something as small as a prechamber