Prechamber Mod "Flame" Front
Prechamber Mod "Flame" Front
(07-06-2012, 05:34 PM)OM616(07-05-2012, 12:28 AM)barrote OM606, as i understood even for a stock engine would help to enlarge the holes.
We must never forget that this engines are line production , and are not blue printed. that´s what we want to do.
Do u have any idea of which increase should one do for 60X PC, i will do it and post the results , just want to start from where u guys arrived . i want to save time and money.
by the way have u or know of anyone which has a repair manual for 60X engines? or web site to go to?
regards
FD
Yes, a stock engine will benefit, the biggest bonus being you can advance the injection timing.
The 60X PC has more holes than the 61X PC so the additional area adds up quick, it doesn’t take much per hole. My notes say that the 60X PC has 8, 2.5mm holes and a 8mm burn tube.
IMOP increasing all the burn holes to 2.75mm or 3.00mm would be with in reason. I would recommend that you try and contact jeemu (I apologize if I spelled it wrong), he has a project car in that section, and he has built 500+HP 60X engines.
Definitely get a service manual as you will need the torque specks for the PCs and Injectors, you can find them on e-bay some times, not sure if there is a link to a manual on this sight.
Don’t forget to pull the glow plugs out first, BEFORE you remove the PCs.
(07-06-2012, 05:34 PM)OM616(07-05-2012, 12:28 AM)barrote OM606, as i understood even for a stock engine would help to enlarge the holes.
We must never forget that this engines are line production , and are not blue printed. that´s what we want to do.
Do u have any idea of which increase should one do for 60X PC, i will do it and post the results , just want to start from where u guys arrived . i want to save time and money.
by the way have u or know of anyone which has a repair manual for 60X engines? or web site to go to?
regards
FD
Yes, a stock engine will benefit, the biggest bonus being you can advance the injection timing.
The 60X PC has more holes than the 61X PC so the additional area adds up quick, it doesn’t take much per hole. My notes say that the 60X PC has 8, 2.5mm holes and a 8mm burn tube.
IMOP increasing all the burn holes to 2.75mm or 3.00mm would be with in reason. I would recommend that you try and contact jeemu (I apologize if I spelled it wrong), he has a project car in that section, and he has built 500+HP 60X engines.
Definitely get a service manual as you will need the torque specks for the PCs and Injectors, you can find them on e-bay some times, not sure if there is a link to a manual on this sight.
Don’t forget to pull the glow plugs out first, BEFORE you remove the PCs.