Electronic variable vane control
Electronic variable vane control
(01-12-2009, 09:03 PM)oel_brenner(01-12-2009, 08:49 PM)winmutt(01-12-2009, 07:56 PM)oel_brenner all of this is assuming we have (or can get) the CAN-bus protocol specifics for the electronic OM606 pump, and related sensors. but even if we can't just sniff them off the bus and document it yourself.If you moved the oil can you could control the rack with a voice coil. It wouldnt be easy by a far shot. With an '85 you can read rack position though. I was outside earlier this evening trying to figure out how the sensor works. Someone around here had a post of how it operated. Forced?
How many HP does that vac pump pull you think?
are you talking about retrofitting EMS onto a OM603 / OM61x
(non-electronic) engine ?
I was talking about running an already all electronic OM606 engine with a stand-alone open-source controller. Using CB comm protocols.
(01-12-2009, 09:03 PM)oel_brenner(01-12-2009, 08:49 PM)winmutt(01-12-2009, 07:56 PM)oel_brenner all of this is assuming we have (or can get) the CAN-bus protocol specifics for the electronic OM606 pump, and related sensors. but even if we can't just sniff them off the bus and document it yourself.If you moved the oil can you could control the rack with a voice coil. It wouldnt be easy by a far shot. With an '85 you can read rack position though. I was outside earlier this evening trying to figure out how the sensor works. Someone around here had a post of how it operated. Forced?
How many HP does that vac pump pull you think?
are you talking about retrofitting EMS onto a OM603 / OM61x
(non-electronic) engine ?
I was talking about running an already all electronic OM606 engine with a stand-alone open-source controller. Using CB comm protocols.