A little help....w123
A little help....w123
MDEMING
Hey gang. I was going through the car yesterday taking stock on the issues and found this wire tucked into the spring mount hole. It comes from the coolant and looks like a ground but I don't know where to attach it. I'm sure this is a basic deal but I don't have a lot of resources on hand. Any help would be appreciated; photo would be really appreciated.
MDEMING
1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running
willbhere4u
12-07-2010, 03:38 PM #5I think it went to the LH side of the engine up in front of the valve cover to the wiring harness for the glow plugs but I could be wrong!
1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running
1982 300D Turbo ... 3,6xxlbs, No fan, No AC, Hood Stack, No ALDA, No rear bumper and stuffed front, A/W Intercooled, Injectors by Greezer and HUGE Pre-Chambers with help from OM616 & Simpler=Better, Fuel Cranked up, 60 Trim Compressor wheel, EGT, EMP, Boost 50" Rigid Radius bar on roof Aux tank for a total of 48 Gal Of Diesel! Odyssey PC-1750 Battery in trunk, 27"x8.5"/R14 Maxxis BigHorn Mud Terrains, In June '14 issue of Off Road Mag
AX15 Jeep Trans swap in progress....
Captain America
12-07-2010, 04:12 PM #6The end in the second pic looks like the female side... That end connects to the male terminal in the T-stat housing (which I believe is a 40*C switch) and the wire leads back into the harness around the coolant tank.
1982 300D Turbo ... 3,6xxlbs, No fan, No AC, Hood Stack, No ALDA, No rear bumper and stuffed front, A/W Intercooled, Injectors by Greezer and HUGE Pre-Chambers with help from OM616 & Simpler=Better, Fuel Cranked up, 60 Trim Compressor wheel, EGT, EMP, Boost 50" Rigid Radius bar on roof Aux tank for a total of 48 Gal Of Diesel! Odyssey PC-1750 Battery in trunk, 27"x8.5"/R14 Maxxis BigHorn Mud Terrains, In June '14 issue of Off Road Mag
AX15 Jeep Trans swap in progress....
The 2nd photo is where the wire has a connection and connects just under the coolant tank. The first photo is the bare wire I found tucked into the spring mount. The wire is clamped to a hose at about half of its length. Since it's a bare wire the best I can do appears to be wrap it around what appears to be projection coming out from the t-housing (i'll take a photo tomorrow). This may explain why my d$%ned A/C would work for all of 5 minutes at a time this summer until suddenly blowing air from the 10th ring of Hades, usually after a downshift. The dealer wanted to throw parts at it, starting with a compressor; evap was mentioned, that would have been expensive....
1982 300D Turbo ... 3,6xxlbs, No fan, No AC, Hood Stack, No ALDA, No rear bumper and stuffed front, A/W Intercooled, Injectors by Greezer and HUGE Pre-Chambers with help from OM616 & Simpler=Better, Fuel Cranked up, 60 Trim Compressor wheel, EGT, EMP, Boost 50" Rigid Radius bar on roof Aux tank for a total of 48 Gal Of Diesel! Odyssey PC-1750 Battery in trunk, 27"x8.5"/R14 Maxxis BigHorn Mud Terrains, In June '14 issue of Off Road Mag
AX15 Jeep Trans swap in progress....
Captain America
12-07-2010, 11:41 PM #8Bahahaha! Stupid dealer! I think that wire needs to see ground to turn the blower on... so that you don't get cold air when you turn the heater on...
1982 300D Turbo ... 3,6xxlbs, No fan, No AC, Hood Stack, No ALDA, No rear bumper and stuffed front, A/W Intercooled, Injectors by Greezer and HUGE Pre-Chambers with help from OM616 & Simpler=Better, Fuel Cranked up, 60 Trim Compressor wheel, EGT, EMP, Boost 50" Rigid Radius bar on roof Aux tank for a total of 48 Gal Of Diesel! Odyssey PC-1750 Battery in trunk, 27"x8.5"/R14 Maxxis BigHorn Mud Terrains, In June '14 issue of Off Road Mag
AX15 Jeep Trans swap in progress....
1 Guest(s)
1 Guest(s)