IP Full Load Adjustment Procedure for the MW and M pumps
IP Full Load Adjustment Procedure for the MW and M pumps
Make any progress?
I adjusted my pump today using the settings you made on the full load, coarse idle and idle stablizer today.
The power is diffinitely nice, BUT the idle was $hit, it would either not come down or would rise to 3000 rpms. I tweaked the idle stablizer screw and ended up with 4 turns ccw - that is the correct direction to move it, ask me how I know
I am getting to the point where I can pull the pump and make the adjustments and put it back in in about 20 minutes. I pulled the pump 5 times today!
I finally adjusted the torque capsule to the initial setting that it was when I received the pump. The idle is now stable, but the power seems to be back to where it was before I adjusted the full load and coarse idle screws.
I am going to readjust the torque capsule and use 1/4 turn increments until the idle bocomes undesireable.
These are my settings thus far:
Idle fine: No clue, too may turns to count
Idle coarse: 5.25 CCW
Full Load: 5.00 CCW
Max RPM : .5 CW
Idle Stablizer: 4 CCW