IP Full Load Adjustment Procedure for the MW and M pumps
IP Full Load Adjustment Procedure for the MW and M pumps
Yeah, I set it to 27 from 26 btdc.
I also just went for a drive with the idle high and the mentioned settings the same except the vert throt screw I turned another full turn out. The response without boost was about the same if not better than before, but I am not getting chit for boost. At the top of the rpms, i get maybe 5 psi. I am thinking that besides the idle not going down, my wastegate may be stuck open, causing a lot of power loss. I'll have to borrow a vacuum tester and see if the wastegate is stuck.
On my previous post, the no power was with the vert throttle screw turned 9 CCW. There I can get a decent idle with a really fast return to idle, but absolutely no power.