IP Full Load Adjustment Procedure for the MW and M pumps
IP Full Load Adjustment Procedure for the MW and M pumps
Spent about and hour and a half this morning tearing apart the boxes in the garage to no avail. I did have the sh*t-clip still, and found the washer under my car! A quick check in the parts bin, turns out one of the spare springs for my rc buggy fits! So I put that in with the washer and clip and reinstalled my alda. TRIED to take it for a test drive, but after 15 feet on absolutely no power, I stopped and limped it right back into the garage. Turns out that spring is just a fraction of an inch too wide and interferes with the alda. I pulled the alda completely off (left the spring in) and test drove again, WOO HOO!! I have power again! No video yet, but my friend is going to let me borrow his hero-cam once he finds it again. The low end torque is much better now. I was actually able to spin tires on wet pavement again! In about 2 weeks I should have a day off to hit the dyno again and see where the Pumpkin is at for power.