Holset HX35 Install info on om603
Holset HX35 Install info on om603
Ok, that all sounds great. I am familiar with the push-lock hose and JIC fittings from a place I used to work that built fuel tanks and enclosures for the generator industry. I have not seen what the current oil lines look like but I am assuming they are metal pipes with flanges on each end. Is this correct?
Once the Holset is in place, I am assuming that I can weld a male end to a flange to adapt to the JIC fitting? I know I am asking alot! So essentially I could have each hose with female JICs on each end, and have male JICs welded on a bracket for where each connects to turbo and engine?