My 1987 300D
My 1987 300D
Smooth as glass. The yoke was indeed bent, however I think I am going to have to redo the whole driveshaft. Its the smaller diameter one and I dont think there is enough rubber around the carrier bushing on the drive shaft. Still getting the "bucking" at certain light loads. I will post up on the various subframe and diff mounts and create a "meta thread" incorporating all of the available options, including Ake's poly subframes bushings.
Also, I threw in a 210 rear bar, 17 or 18mm. Not sure I like the lack of over steer, it might have been too much for the 400e bar on the front (time for something bigger up front?) Either way it was a perfect fit after I move some fuel lines around.