Turbo/Alda pressure
Turbo/Alda pressure
I’m currently running my turbo actuator and Alda pressure from ports in my custom intake manifold on my 605. My thoughts on this where that they would be a more accurate and real time pressure reading. Ive just finished my exhaust manifold and I’m putting on an s200 and going to see what power I can get out of her. I think I would be better running everything straight from the compressor housing as I think full fuel is coming on too late with the current setup. Where does everyone else run there actuator and Alda pipes from??
(11-09-2018, 03:11 PM)Mallinman I’m currently running my turbo actuator and Alda pressure from ports in my custom intake manifold on my 605. My thoughts on this where that they would be a more accurate and real time pressure reading. Ive just finished my exhaust manifold and I’m putting on an s200 and going to see what power I can get out of her. I think I would be better running everything straight from the compressor housing as I think full fuel is coming on too late with the current setup. Where does everyone else run there actuator and Alda pipes from??
(11-09-2018, 03:11 PM)Mallinman I’m currently running my turbo actuator and Alda pressure from ports in my custom intake manifold on my 605. My thoughts on this where that they would be a more accurate and real time pressure reading. Ive just finished my exhaust manifold and I’m putting on an s200 and going to see what power I can get out of her. I think I would be better running everything straight from the compressor housing as I think full fuel is coming on too late with the current setup. Where does everyone else run there actuator and Alda pipes from??
(11-09-2018, 03:11 PM)Mallinman I’m currently running my turbo actuator and Alda pressure from ports in my custom intake manifold on my 605. My thoughts on this where that they would be a more accurate and real time pressure reading. Ive just finished my exhaust manifold and I’m putting on an s200 and going to see what power I can get out of her. I think I would be better running everything straight from the compressor housing as I think full fuel is coming on too late with the current setup. Where does everyone else run there actuator and Alda pipes from??
(11-09-2018, 03:11 PM)Mallinman I’m currently running my turbo actuator and Alda pressure from ports in my custom intake manifold on my 605. My thoughts on this where that they would be a more accurate and real time pressure reading. Ive just finished my exhaust manifold and I’m putting on an s200 and going to see what power I can get out of her. I think I would be better running everything straight from the compressor housing as I think full fuel is coming on too late with the current setup. Where does everyone else run there actuator and Alda pipes from??