STD Tuning Engine Bench testing, no oil pressure

Bench testing, no oil pressure

Bench testing, no oil pressure

 View a Printable Version
 
  • 0 Vote(s) - 0 Average
 
moroza
Find
Naturally-aspirated

22
06-11-2020, 11:08 PM #1
Reply
Reply
606 turbo strapped to a pallet, several jumpercables and a battery connected to the starter, oil in the pan at least halfway up the dipstick. Both the 6mm Allen plug on the oilfilter housing, and the turbo oil pressure line, are open. Cranked at least six times, mostly 3-5 seconds and never more than 10 seconds at a time, and there's nothing more than residual trickle out of either hole. Any ideas? How long should these take to build pressure?

EDIT: the oil cooler lines were cut, and are connected to each other. I've not yet taken apart the connection to see if there's flow there.
This post was last modified: 06-11-2020, 11:17 PM by moroza.
moroza
06-11-2020, 11:08 PM #1

606 turbo strapped to a pallet, several jumpercables and a battery connected to the starter, oil in the pan at least halfway up the dipstick. Both the 6mm Allen plug on the oilfilter housing, and the turbo oil pressure line, are open. Cranked at least six times, mostly 3-5 seconds and never more than 10 seconds at a time, and there's nothing more than residual trickle out of either hole. Any ideas? How long should these take to build pressure?

EDIT: the oil cooler lines were cut, and are connected to each other. I've not yet taken apart the connection to see if there's flow there.

Reply
Reply
 View a Printable Version
 
  • 0 Vote(s) - 0 Average

Messages In This Thread
Bench testing, no oil pressure - by moroza - 06-11-2020, 11:08 PM
RE: Bench testing, no oil pressure - by junkyarddawg - 06-12-2020, 06:48 AM
RE: Bench testing, no oil pressure - by zeeman - 06-12-2020, 10:28 AM
RE: Bench testing, no oil pressure - by moroza - 06-12-2020, 04:32 PM
Users browsing this thread:
 1 Guest(s)
Users browsing this thread:
 1 Guest(s)