STD Tuning Engine OM 606 Deck Height

OM 606 Deck Height

OM 606 Deck Height

 
  • 0 Vote(s) - 0 Average
 
zeeman
Holset

444
05-05-2020, 11:19 AM #1
I have a 606 block in the machine shop to be bored for new pistons. They just called and suggested that it needs to be surfaced to clean up the head gasket surface.
What is the allowed amount that can be taken off to be safe? If it is an issue we can always resize the rods to make up the difference.
zeeman
05-05-2020, 11:19 AM #1

I have a 606 block in the machine shop to be bored for new pistons. They just called and suggested that it needs to be surfaced to clean up the head gasket surface.
What is the allowed amount that can be taken off to be safe? If it is an issue we can always resize the rods to make up the difference.

 
  • 0 Vote(s) - 0 Average

Messages In This Thread
OM 606 Deck Height - by zeeman - 05-05-2020, 11:19 AM
RE: OM 606 Deck Height - by barrote - 05-06-2020, 11:32 AM
RE: OM 606 Deck Height - by zeeman - 05-06-2020, 12:11 PM
RE: OM 606 Deck Height - by AlanMcR - 05-07-2020, 03:41 PM
Users browsing this thread:
 1 Guest(s)
Users browsing this thread:
 1 Guest(s)