Sprinter SMF Kits
Sprinter SMF Kits
08-12-2019, 03:33 PM
#1
I've been told that the tab on the crank is 11.3mm and the key hole for the tab that's on the flywheel is only 10.3mm deep. Such as this thread here
https://www.mb4x4.co.za/index.php?thread...heel.2791/
I'm confused - i almost want to remove my trans and flywheel to verify everything with a caliper. Whats your experience with this?
I've seen varying views on using Sprinter SMF on the OM606. I currently have a sprinter Single mass flywheel and clutch kit on my OM606 and 716.xxx from a C230 kompressor.
I've been told that the tab on the crank is 11.3mm and the key hole for the tab that's on the flywheel is only 10.3mm deep. Such as this thread here
https://www.mb4x4.co.za/index.php?thread...heel.2791/
I'm confused - i almost want to remove my trans and flywheel to verify everything with a caliper. Whats your experience with this?
Messages In This Thread
Sprinter SMF Kits - by WDiesel - 08-12-2019, 03:33 PM
RE: Sprinter SMF Kits - by Petar - 08-13-2019, 04:58 AM
RE: Sprinter SMF Kits - by WDiesel - 08-15-2019, 01:09 AM
RE: Sprinter SMF Kits - by crodgers - 03-03-2020, 10:03 AM
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Users browsing this thread:
1 Guest(s)
1 Guest(s)