Torque cylinder head bolts
Torque cylinder head bolts
Hello
I Mounted my cylinder head on my om606 and I used the following torque
First 15nm then 35nm then 90 degree waited for 10 min and then 90 degree again
unfortunately I hade to remove the cylinder head again and when I did that after 3 days
And when I did that I could easy losen the bolts and I saw that the bolts has not been stretched as the old ones had, and the old ones was realy hard to get lose
Have I missed something I am going to install the cylinder head again now in the weekend with new gasket and new bolts
Shall I put some copper spray a gasket on the new gasket to get extra seal?