STD Tuning Engine M pump DIY calibration

M pump DIY calibration

M pump DIY calibration

 
  • 0 Vote(s) - 0 Average
 
engineengineer
Naturally-aspirated

20
03-10-2019, 11:44 AM #1
Hi, I have got an om606 crudely fitted in a speed boat with 5.5mm elements. I wish to change the elements for 6mm ones from an edc pump.
 I am aware that the pump should be calibrated for proper phasing etc, but wandered if I was to install elements and balance best I could on a homemade flow bench (I believe by adjustment on the rack?) whether the engine is likely to run smooth enough. It does not have to run super smooth. 
Has anyone on here rebuilt their own M pump?
Thanks, Jack
engineengineer
03-10-2019, 11:44 AM #1

Hi, I have got an om606 crudely fitted in a speed boat with 5.5mm elements. I wish to change the elements for 6mm ones from an edc pump.
 I am aware that the pump should be calibrated for proper phasing etc, but wandered if I was to install elements and balance best I could on a homemade flow bench (I believe by adjustment on the rack?) whether the engine is likely to run smooth enough. It does not have to run super smooth. 
Has anyone on here rebuilt their own M pump?
Thanks, Jack

 
  • 0 Vote(s) - 0 Average

Messages In This Thread
M pump DIY calibration - by engineengineer - 03-10-2019, 11:44 AM
RE: M pump DIY calibration - by R-3350 - 03-10-2019, 12:27 PM
RE: M pump DIY calibration - by engineengineer - 03-10-2019, 01:04 PM
RE: M pump DIY calibration - by Petar - 03-10-2019, 02:00 PM
Users browsing this thread:
 2 Guest(s)
Users browsing this thread:
 2 Guest(s)