STD Tuning Engine DIY element swap

DIY element swap

DIY element swap

 View a Printable Version
 
  • 0 Vote(s) - 0 Average
 
engineengineer
Find
Naturally-aspirated

20
02-02-2019, 01:01 PM #1
Reply
Reply
Hi all, if I was to swap the 6mm elements from a 606 EDC pump into my 5.5mm RSF n/a606 pump, what are the chances of it running right without being setup on a bench? If not, are there any DIY methods to balance the pump? 
Thanks
engineengineer
02-02-2019, 01:01 PM #1

Hi all, if I was to swap the 6mm elements from a 606 EDC pump into my 5.5mm RSF n/a606 pump, what are the chances of it running right without being setup on a bench? If not, are there any DIY methods to balance the pump? 
Thanks

Reply
Reply
 View a Printable Version
 
  • 0 Vote(s) - 0 Average

Messages In This Thread
DIY element swap - by engineengineer - 02-02-2019, 01:01 PM
RE: DIY element swap - by baldur - 02-02-2019, 01:46 PM
RE: DIY element swap - by engineengineer - 02-02-2019, 08:54 PM
RE: DIY element swap - by baldur - 02-03-2019, 05:24 PM
RE: DIY element swap - by mmetzdavid - 02-04-2019, 08:37 AM
RE: DIY element swap - by zeeman - 02-04-2019, 12:12 PM
Users browsing this thread:
 1 Guest(s)
Users browsing this thread:
 1 Guest(s)