STD Tuning Engine Industrializing an OM606

Industrializing an OM606

Industrializing an OM606

 
  • 0 Vote(s) - 0 Average
 
llopness
K26-2

48
01-11-2019, 03:04 PM #1
I have a skid steer (1990 Hydra Mac 2650D) with an Onan L634 (Cummins 6A) idi 65kw @3600rpm. it's loud, hard to start(stupid stanadyne pump) and has little torque, so has to be revved at least part way to do much.

OM606 addresses all the above issues and can rev higher for potentially faster travel speed on very smooth surfaces.  only drawback would be reducing weight, which might actually be nice as it's very rear heavy and easily tips backwards with an empty bucket.

Can one set up an OM603 Injection pump to be governed?  Is there a controller for the EDC pump where one can easily input governed speed? will the OM606 object to having a PTO belt come off the front?


more of a hypothetical at this point, unless it dies, or I find the Cummins to be worth a pile of money on eBay.  refurbed units appear to be listed for ~$7500.
llopness
01-11-2019, 03:04 PM #1

I have a skid steer (1990 Hydra Mac 2650D) with an Onan L634 (Cummins 6A) idi 65kw @3600rpm. it's loud, hard to start(stupid stanadyne pump) and has little torque, so has to be revved at least part way to do much.

OM606 addresses all the above issues and can rev higher for potentially faster travel speed on very smooth surfaces.  only drawback would be reducing weight, which might actually be nice as it's very rear heavy and easily tips backwards with an empty bucket.

Can one set up an OM603 Injection pump to be governed?  Is there a controller for the EDC pump where one can easily input governed speed? will the OM606 object to having a PTO belt come off the front?


more of a hypothetical at this point, unless it dies, or I find the Cummins to be worth a pile of money on eBay.  refurbed units appear to be listed for ~$7500.

 
  • 0 Vote(s) - 0 Average

Messages In This Thread
Industrializing an OM606 - by llopness - 01-11-2019, 03:04 PM
RE: Industrializing an OM606 - by baldur - 01-11-2019, 03:15 PM
RE: Industrializing an OM606 - by llopness - 01-11-2019, 05:11 PM
RE: Industrializing an OM606 - by baldur - 01-11-2019, 07:31 PM
RE: Industrializing an OM606 - by jav1 - 01-11-2019, 03:20 PM
RE: Industrializing an OM606 - by llopness - 01-11-2019, 04:44 PM
RE: Industrializing an OM606 - by barrote - 01-14-2019, 04:20 AM
Users browsing this thread:
 1 Guest(s)
Users browsing this thread:
 1 Guest(s)