why wont my camshaft fit?
why wont my camshaft fit?
04-21-2017, 03:42 PM
#7
Been reading up on this because I have to pull the lifters and clean them out because it's clackity clack clack at idle..
Beers,
HH
This post was last modified: 04-21-2017, 03:43 PM by Hario'.
Installed:
OM606/722.6, big IC, W220 brakes.
Planned:
DIY manifold, compound, 722.6 controller, built IP.
[i]Less rust.. [/i]
Yes you align the crank to TDC (OT on the damper), the align #1 to inlet stroke where both cam lobes are up (more like in & ex lobes are up at about 2-3 o'clock), the gently wind down the bolts in sequence, 180 degrees at a time or whatever it is.
Been reading up on this because I have to pull the lifters and clean them out because it's clackity clack clack at idle..
Beers,
HH
Installed:
OM606/722.6, big IC, W220 brakes.
Planned:
DIY manifold, compound, 722.6 controller, built IP.
[i]Less rust.. [/i]
Messages In This Thread
why wont my camshaft fit? - by BoostedW124 - 04-21-2017, 08:58 AM
RE: why wont my camshaft fit? - by hooblah - 04-21-2017, 09:08 AM
RE: why wont my camshaft fit? - by Evgeniy1987 - 04-21-2017, 09:25 AM
RE: why wont my camshaft fit? - by BoostedW124 - 04-21-2017, 09:26 AM
RE: why wont my camshaft fit? - by AlanMcR - 04-21-2017, 12:02 PM
RE: why wont my camshaft fit? - by BoostedW124 - 04-21-2017, 12:58 PM
RE: why wont my camshaft fit? - by Hario' - 04-21-2017, 03:42 PM
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Users browsing this thread:
1 Guest(s)
1 Guest(s)