STD Tuning Engine OM 606 Deck Height

OM 606 Deck Height

OM 606 Deck Height

 
  • 0 Vote(s) - 0 Average
 
zeeman
Holset

444
05-05-2020, 11:19 AM #1
I have a 606 block in the machine shop to be bored for new pistons. They just called and suggested that it needs to be surfaced to clean up the head gasket surface.
What is the allowed amount that can be taken off to be safe? If it is an issue we can always resize the rods to make up the difference.
zeeman
05-05-2020, 11:19 AM #1

I have a 606 block in the machine shop to be bored for new pistons. They just called and suggested that it needs to be surfaced to clean up the head gasket surface.
What is the allowed amount that can be taken off to be safe? If it is an issue we can always resize the rods to make up the difference.

barrote
Superturbo

1,627
05-06-2020, 11:32 AM #2
A lot... if needed. Just to clear a gasket .1mm sufice and u can use a stock gasket. But u should acess CR

FD,
Powered by tractor fuel
barrote
05-06-2020, 11:32 AM #2

A lot... if needed. Just to clear a gasket .1mm sufice and u can use a stock gasket. But u should acess CR


FD,
Powered by tractor fuel

zeeman
Holset

444
05-06-2020, 12:11 PM #3
barrote A lot... if needed. Just to clear a gasket .1mm sufice and u can use a stock gasket. But u should acess CR
Are there any thicker head gaskets available?
zeeman
05-06-2020, 12:11 PM #3

barrote A lot... if needed. Just to clear a gasket .1mm sufice and u can use a stock gasket. But u should acess CR
Are there any thicker head gaskets available?

AlanMcR
mind - blown

400
05-07-2020, 03:41 PM #4
A6060160520 Cylinder head gasket 1.85mm (vs. 1.65mm)
AlanMcR
05-07-2020, 03:41 PM #4

A6060160520 Cylinder head gasket 1.85mm (vs. 1.65mm)

 
  • 0 Vote(s) - 0 Average
Users browsing this thread:
 1 Guest(s)
Users browsing this thread:
 1 Guest(s)