+- STD (https://www.superturbodiesel.com/std)
+-- Forum: Tuning (https://www.superturbodiesel.com/std/forumdisplay.php?fid=6)
+--- Forum: Engine (https://www.superturbodiesel.com/std/forumdisplay.php?fid=7)
+--- Thread: garrett gt23v turbo compressor housings (/showthread.php?tid=8443)
garrett gt23v turbo compressor housings - 50harleyrider - 01-23-2021
Can anyone tell me where to look for a compressor housing that may have an outlet connection more friendly to aftermarket IC boost piping? Mine has a plug-in oring connection used on the om648 w211 and to get a hose to stay over it with a t-bolt clamp is not good and slips off. Friction is not a sufficient clamping system for it.
RE: garrett gt23v turbo compressor housings - X Double Dot - 01-23-2021
Id recommend buying a piece of tubing at whatever diameter you want with the bead rolling on it and just cut the end off and weld it to the compressor outlet. I get the sections from siliconintakes.com
RE: garrett gt23v turbo compressor housings - baldur - 01-24-2021
We just weld a piece of pipe to the compressor housing to cure this problem.
RE: garrett gt23v turbo compressor housings - 50harleyrider - 01-25-2021
I rcently bought a Miller MIG welder with an aluminum wire spool gun so I guess it's time to try it out.
RE: garrett gt23v turbo compressor housings - 50harleyrider - 01-28-2021
I went ahead and ordered the oe plastic silencer the W211 had on the compressor outlet. will try that b4 I start modifying the outlet.