+- STD (https://www.superturbodiesel.com/std)
+-- Forum: Tuning (https://www.superturbodiesel.com/std/forumdisplay.php?fid=6)
+--- Forum: Engine (https://www.superturbodiesel.com/std/forumdisplay.php?fid=7)
+--- Thread: M103 w201 -> OM606 swap (/showthread.php?tid=8292)
M103 w201 -> OM606 swap - keiffith - 12-11-2019
I'm in the US so it took years to source an OM606. Found one 1 mile from my house.
I have a M103 auto w201 that I want to swap.
What I know
-w124 mounts with stock w210 arms will bolt in after 10mm is shaved from the mounts
-vaccum cutoff
What I need to know
-will the front AC fan be adequate enough for cooling if wired to turn on at 85-90*C
-what rad hoses to use with my stock radiator
Where to pin the glow plug harness into the stock location (doing push button so I just need to know where it normally gets power)
Will the m103 p/s pump and a/c comp bolt to the om606
Thanks for the help
RE: M103 w201 -> OM606 swap - Bigpanda16 - 12-14-2019
Use a ford remote starter solenoid for the glow plugs.
All the accessories should bolt up, the block is essentially the same. Even the oil pan would bolt up
RE: M103 w201 -> OM606 swap - benzguy - 12-17-2019
I don’t think you can use the radiator from the 103 engine different position water outlets I did a similar swap I used a radiator from the 190D turbo
RE: M103 w201 -> OM606 swap - benzguy - 12-17-2019
The p/s will work with the 606 but a/c compressor will not bolt on use the 606 accessories
RE: M103 w201 -> OM606 swap - Ace - 11-06-2021
hallo,
wie weit ist der umabu ich plane den selben gerade ich deutschland
ich habe das problem mit der wegfahrsperre bei der elektronischen pumpe hast du da eine lösung gefunden ?
mfg
RE: M103 w201 -> OM606 swap - Steve77 - 11-07-2021
@Ace:
Here is described, how to run the OM606 standalone with the OEM-Ecu: http://www.superturbodiesel.com/std/showthread.php?tid=7547
I am from Germany too, but I think, it's better to write in English in this forum.
RE: M103 w201 -> OM606 swap - Ace - 03-28-2022
(11-07-2021, 05:29 AM)Steve77 @Ace:
Hier ist beschrieben, wie man den OM606 Standalone mit dem OEM-Ecu betreibt: http://www.superturbodiesel.com/std/showthread.php?tid=7547
Ich komme auch aus Deutschland, aber ich denke, es ist besser um in diesem Forum auf Englisch zu schreiben.
hi,
Ja das mag sein nur leider ist mein eng mehr als schlecht
mfg
Cord