Om606 oil pressure port - Printable Version +- STD (https://www.superturbodiesel.com/std) +-- Forum: Tuning (https://www.superturbodiesel.com/std/forumdisplay.php?fid=6) +--- Forum: Engine (https://www.superturbodiesel.com/std/forumdisplay.php?fid=7) +--- Thread: Om606 oil pressure port (/showthread.php?tid=8004)

Om606 oil pressure port - Antonytriolo - 03-20-2018 Evening  Is there a spare port on a om605 turbo diesel that I can use for a oil pressure sensor for my digital dash on my landrover project? RE: Om606 oil pressure port - baldur - 03-20-2018 Yes. There's a port on the filter housing that is plugged up. I believe it has a M14x1.5 thread. RE: Om606 oil pressure port - Antonytriolo - 03-20-2018 Thanks baldur It that the one on the side of the housing above the starter motor? I think there’s one on the back too that I could feel, I might be wrong as I havnt looked RE: Om606 oil pressure port - baldur - 03-20-2018 Yes, above the starter motor, it's the one bolt there not circled. RE: Om606 oil pressure port - baldur - 03-20-2018 I can't say for sure whether it's M12 or M14, it's been a while since I checked. RE: Om606 oil pressure port - Antonytriolo - 03-21-2018 Aah yes I did see that just wasn’t sure. I will take it out as I will need a adapter to convert it 1/8npt thread along with getting a T piece for the water temperature as my digital dash is calibrated to its own sender RE: Om606 oil pressure port - TIMNZ - 04-10-2018 Have just done this, it is M12 x 1.5 mm,   I used a hex head set screw, drilled and tapped the head with 1/8" NPT drilled 3mm hole, and used 2 sealing washers as thread didn't quite go all the way up to the head. Cheers Tim