+- STD (https://www.superturbodiesel.com/std)
+-- Forum: Tuning (https://www.superturbodiesel.com/std/forumdisplay.php?fid=6)
+--- Forum: Engine (https://www.superturbodiesel.com/std/forumdisplay.php?fid=7)
+--- Thread: adapting to t3 flange (/showthread.php?tid=7215)
adapting to t3 flange - LewisG95 - 05-18-2016
Hi,
I am just wondering what people have done with converting the 3 bolt merc flange to a t3 flange? Does anyone else sell the adapters other than dieselpumpuk or do I have to get the 3 bolt flange machined up myself? I don't really fancy paying £160+ on a manifold adapter really...
Thanks
RE: adapting to t3 flange - TurboTim - 05-18-2016
I just welded a cast 45 to T3 flange. Actually had cast elbow from 603 mani.
RE: adapting to t3 flange - 50harleyrider - 05-18-2016
Lewis,
I bought an adapter from Hario in UK on here. PM him about your needs. He's a nice guy and will help you. He made a header. Look at his thread to see. You may want to go his route. Depending on your HP needs, a simple adapter on the oe manifold may not suffice. I went the adapter route because my HP requirement is only 250-300.
RE: adapting to t3 flange - LewisG95 - 05-18-2016
I have seen a cast 45 degree elbow to a t3 flange on another thread, I'm not sure if it was yours TurboTim? That was one way I was thinking of going with it.
At the moment I am only aiming for 250hp if possible. I don't want to play around with the IP just yet. I will send Hario a PM now though. Thanks
