will a .9 bolt up to OM 60x??
I would have to check on the bolt pattern but theres no way you could get the control module and software to run that thing. Plus the dot 9 has way more problems than the dot 6, if anything look into that. I am assuming you came accross a cheap dot 9
(05-29-2009 04:39 PM)MB TECH Wrote: [ -> ]......but theres no way you could get the control module and software to run that thing. ....I am assuming you came accross a cheap dot 9 .....
These folks might be able to help in controlling it.
http://www.powertraincontrolsolutions.com/miltrans.php
Might be expensive though... Which will defeat the cheap in the "cheap dot 9".
(05-29-2009 04:39 PM)MB TECH Wrote: [ -> ]I am assuming you came accross a cheap dot 9
nah... just speculating... and daydreaming about 7 gears, and this after my 4 speed swap!! It would just be one more thing to keep an eye out for at the yards and/or on CL... I wouldnt think controlling it would be too difficult, via a solution like DV linked or something similar...
(05-29-2009 06:36 PM)DeliveryValve Wrote: [ -> ]Which will defeat the cheap in the "cheap dot 9".
not *too* worried about the 'cheap', if I could get it to work, I'd be pretty stoked....if I came across one, I'd prolly go out and buy something with a 603 just to use it...
(05-29-2009 04:15 PM)SurfRodder Wrote: [ -> ]will a .9 bolt up to OM 60x??
Yes it will,it has been done in this contry. But I´m not sure wich one of the 722.9
This is very interesting!!!I don't see the exactly price of the controller....
(01-23-2010 02:47 PM)gvp Wrote: [ -> ]This is very interesting!!!I don't see the exactly price of the controller....
750. But in their application notes, there's no off the shelf setup for the 722.6. They direct you instead to an installer who does that for you. (likely more $)
but if I ever get to do a "franken automatic" this might be the way to go.
Quote:750. But in their application notes, there's no off the shelf setup for the 722.6. They direct you instead to an installer who does that for you. (likely more $)
but if I ever get to do a "franken automatic" this might be the way to go.
It seems nice....i ll have it in my mind for next project...
Does anybody here know if there are any company in europe that are selling or making transmission controlers?
Now I know that it is verry do able..
