[-]
Board Rules
Some simple board rules have been posted. I recommend that you read and follow them so that we can all enjoy this shared resource. Last updated on 3/14/11 Board Rules

STD / Tuning / Suspension v / bearing bracket bushing not fully seated

Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
bearing bracket bushing not fully seated
Author Message
300SD81 Offline
GT2256V
***


Posts: 161
Joined: Jun 2008
Location: University of Georgia [#1 Party School!]
Post: #1
bearing bracket bushing not fully seated
Replaced my guide rod mount and bearing bracket bushings today. What are the consequences of having the bushings not be full seated? I could not get the things all the way in no matter what I did, all 4 are currently about 1/4in from being flat with the bottom of the bracket. Are they likely seat themselves over time, or should I try to obtain/make the tool in the FSM used to press them?

[Image: Suspension_Brng_Brkt.jpg]
Ich liebe meine Autos!

1981 Mercedes-Benz 300SD | 156K Miles | 2nd Owner | EGR Disabled [Removal Pending] | ALDA Removed | Straight Pipes | GT2256V??? | Laser Interceptor | Engine swap over summer, hopefully with GT2256V attached...

1981 Mercedes-Benz 300SD | Odo Stopped at 160K (at least 50K more) | EGR Disabled | ALDA All The Way Out | Straight pipes | FM-870 Remote Start Alarm System | B100 Biodiesel | AC Fixed x2 | Trunk crushed in Sad | Retired to garage.

Excessive speeding? It ain't excessive till I redline!
03-14-2010 11:02 PM
Visit this user's website Find all posts by this user Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | superturbodiesel.com | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication